Why Can’t Access Internet After Connecting to the tp links wifi extender?

Are you also the one who is unable to get (tp links wifi extender) Internet Net access after connecting to the router? If yes, then you don't have to worry anymore, our this post will help you to solve this problem, So without any further delay let's get into the solutions.

Solution 1 - Tp links wifi extender

The most common reason for this problem is the physical connection between the router and modem is not done properly. If you are getting an error message on the status page of the router, then your connection between the router and modem is interrupted, Please try to plug it in properly and make sure that the tread message is gone. A significant level answer is that 6G will investigate and incorporate applicable advancements that were forgotten about from 5G.

Solution 2

In some of the cases, the ISP will register the Mac address of your computer or laptop, whenever you try to access the internet for the first time through their cable. If you try to add another router to your internet connection, the ISP won't accept that MAC address, So it needs to be changed. To do so you can follow the below steps:

• Firstly, you have to make sure that you are connected with the right router with the computer or not.
• After that, you have to login to clone mac address Network->MAC Clone ( It is usually located at the left side of the window).
• Then you have to tap on the clone MAC address option( This will clone your mac address to the WAN mac address of the router).

Solution 3 - tp links wifi extender

You can also power on your modem and tp-link router, you can do this by following below given steps:

• Firstly, you have to power Off your tp-link router and your computer’s modem for at least 1 minute.
• After that you have to plug off your modem’s power cable and Coaxial cable.
• Then you have to connect your router to your Tp-link router( Make sure that your router is powered-ON).
• After that you have to plug your modem's power cable into the nearest power station.( Leave your coaxial cable disconnected).
• After 5 to 10 minutes plug your coaxial cable in.
• Wait for a minute or two, till your modem is reconnected then you have to check your IP address and Internet service.

Solution 4

The last thing that you can do is, you can reset and reconfigure your router manually. You can do this by following the below given steps:

• You have to hold the reset button of your router for 15 seconds .
• After that you have to reconfigure your router manually, and dio its quick setup.